Home
  Information
  News
  Products
  CANDIP/AVR
  CANDIP/505
  Features
  Schematics
  Activity board
  Starter kits
  Software
  Download
  Projects
  Order
  Dealers
  Links
What can I do with CANDIP/505?
  • CAN SLIO with your own protocol or with e.g. CANopen, DeviceNet, SDS, CAN Kingdom etc.
  • Smart nodes with PID algorithms for controlling e.g. temperature, motors or valves.
  • Data Acquisition via CAN. Add your favorite SPI/I2C ADC and collect data.
  • Home Automation. Build smart nodes for turning ON/OFF lights, burglar systems etc.
  • Add CAN simple in an existing system via e.g. SPI, RS-232 or your own way.
  • Education. CANDIP/505 offers a very low cost to learn CAN, we have many starter kits options.
  • If you have a customer who want to see a prototype or even a ready product next week.
  • Decentralized smart nodes for e.g. Robots.
  • CAN monitor in an existing system. Add some Leds and you could monitor e.g valves etc.
Features
  • Standard 28 pin DIP board with 0.1" pins, so use a standard DIP28 carrier.
  • 4 layer board for good EMI performance.
  • Needs only a 5VDC/30mA power source (plus 70mA for CAN tranceiver*).
  • Infineon type C505CA working at 16Mhz.
  • 64k user FLASH, 1kbytes user XRAM and 128bytes user EEPROM.
  • ADC with 10bit resolution / 4 channels.
  • Software controller SPI port for expansion.
  • On chip fullCAN-Contorller (CAN 2.0B).
  • 82C250 High Speed CAN transceiver 1Mbit (ISO-11898).
  • MAX202 RS-232 transceiver.
  • MAX825M Reset circuit.
  • No interpreted software, it's programmed with compilers.
  • Posibilities to implement higher level protocols, such as CANopen, DeviceNet etc.
  • PC-Bootloader for program download in Flash-EPROM via the CAN interface.
  • Demosoftware for the individual hardware components.

* Current consumption for CAN tranceiver variates depending how many nodes that are attached, but should be dimensioned for 70mA.


The picture above shows the CANDIP/505 board (both sides) mounted with an C505CA, MAX202, MAX825, 29F010, 74HCT573 and a 82C250 CAN transceiver. You only need to apply power and connectors of your choice and you are up running. No hassle trouble shooting hardware while learning CAN.


CANDIP/505

| Features | Schematics | Activity board | Starter kits | Software |


| Home | Information | News | Products | Download | Projects | Order | Dealers | Links |


© Copyright 2000 LAWICEL. All rights reserved. Images and text used on these pages may not
be copied without written approval from LAWICEL. Information in this document is subject to change
without notice. Other products and companies referred to herein are trademarks or registered
trademarks of their respective companies or mark holders.


Contact webmaster@candip.com for reporting errors on these pages.

These pages where last updated 13/09/2000